Standard Expanding Puller (3″) fits 2.55″ to 3.2″ ID

worldhdd-standart-expanding-pullers

Standard Expanding Puller (3″) fits 2.55″ to 3.2″ ID

$324.00

Product Description

Standard Expanding Puller is designed to grip polyethylene ducting using expanding jaws to grip the inside wall of the duct. This causes the pulling load to be spread around the circumference of the duct and allows a maximum load to be applied without damage to the ducting.

On thin wall ducting, it is recommended that an outer Duct Sleeve be used to prevent the duct from stretching during installation. Use of a duct plugger will help prevent mud and slurry from entering past the puller into the ducting.

Additional Information

Weight 8.4. lbs